Innovate LM-2
| Brand | Innovate Motorsports |
|---|---|
| Model | LM-2 |
| Output Type | Differential mode (signal ground and power supply ground are different) |
| Sensor Type | Bosch LSU 4.2 |
| Fuse | 5A |
Wideband controller with display. Can be connected to 12V battery or a 12V/5A power supply.
Typical installation is a fixed installation in the exhaust pipe, a few centimeters after the manifold junction. In dynamometers, it can be used with an adapter at the exhaust pipe outlet as explained here.
IMPORTANT
Read the manufacturer's instructions and follow the recommendations for position, mounting, and fuse.
Connection to Accudyno
Connect the grounds together
Lambda probe controllers with differential analog output have a negative output different from the battery negative. For them to work properly with Accudyno, all grounds must be connected at a common point, as shown in the figure, since Accudyno has common mode input, not differential.
| Wire/Color | Function | Gyra/Forza |
|---|---|---|
| Red | Positive Power Supply (+) | Battery(+) |
| Black | Negative Power Supply (-) | Battery(-) |
| Lime Green | Analog Output (+) Pin 12 | AIN1 |
| Yellow | Analog Output (-) Pin 5 | GND and Battery(-) |
| Wire/Color | Function | GO/PRO |
|---|---|---|
| Red | Positive Power Supply (+) | Battery(+) |
| Black | Negative Power Supply (-) | Battery(-) |
| Lime Green | Analog Output (+) Pin 12 | Accudyno IN+ (AFR Pin 3) |
| Yellow | Analog Output (-) Pin 5 | Accudyno IN- (AFR Pin 2) and Battery(-) |
AUXILIARY CABLE
The cable colors indicated correspond to the auxiliary cable that Innovate Motorsports sells separately. If you don't have it, you should use the pin number in the auxiliary connector as a reference. A connector numbering diagram is provided.
Calibration
| Voltage | Lambda | AFR (Gasoline) |
|---|---|---|
| 0 V | 0.5 | 7.35 |
| 5 V | 1.52 | 22.39 |